Hi,
Pin diameter is 2.36mm (0.093").
Measured at the top or bottom of the socket?
The bottom may vary a little according to manufacturing tolerance.
Pin circle diameter is 17.45mm (0.687"), pin spacing is 45 degrees, alignment method 7.8mm (0.307") dia, splined center spigot.
Aliases:Octal, A08, A8, B8‑21, I.O. (International Octal), K, O, SK8
Cheers,
Pin diameter is 2.36mm (0.093").
And the pin 1 to pin 5
Measured at the top or bottom of the socket?
The bottom may vary a little according to manufacturing tolerance.
Pin circle diameter is 17.45mm (0.687"), pin spacing is 45 degrees, alignment method 7.8mm (0.307") dia, splined center spigot.
Aliases:Octal, A08, A8, B8‑21, I.O. (International Octal), K, O, SK8
Cheers,
this socket??
http://www.partsexpress.com/pe/showdetl.cfm?&DID=7&Product_ID=1199&CATID=42
I can believe the .093 but the .687 diameter seems
a bit small...
http://www.partsexpress.com/pe/showdetl.cfm?&DID=7&Product_ID=1199&CATID=42
I can believe the .093 but the .687 diameter seems
a bit small...
Hi,
That's because it's measured at the top of the socket.
If I had a PCB mount octal I'd measure it for you...
It should be slightly less than an inch but I suppose you need the exact figure fore your PCB design...
Anyone?
Cheers,
the .687 diameter seems a bit small...
That's because it's measured at the top of the socket.
If I had a PCB mount octal I'd measure it for you...
It should be slightly less than an inch but I suppose you need the exact figure fore your PCB design...
Anyone?
Cheers,
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.