Looking for LTspice tube models

[matejsirk]

Hi, I am looking models for next tubes (triode & pentode):

6J9P
6P15P
6J32P
6J49P
6J52P
6E5P (only pentode)
D3A

THX in advance

 

[artosalo]

I just sent you a PM containing 6j9p, 6p15p (=SV83),6e5p and D3A models.
I think that you do not need any particular triode-models. Just connect g2 to a and go ahead.

 

[matejsirk]

I just sent you a PM containing 6j9p, 6p15p (=SV83),6e5p and D3A models.
I think that you do not need any particular triode-models. Just connect g2 to a and go ahead.

thx

 

[jackinnj]

Hi, I am looking models for next tubes (triode & pentode):
6J52P
THX in advance

Try these parameters:
MU=85 EX=1.5 KG1=63 KP=741 KVB=4700

and (omitting the case in which Vg1=0)

MU=100 EC=1.48 KG1=35.8 KP=445 KVB=2670

An externally hosted image should be here but it was not working when we last tested it.

An externally hosted image should be here but it was not working when we last tested it.

 

[mogliaa]

Here you are
http://www.bartola.co.uk/valves/2013/11/17/6ж52п-6z52p-in-triode-mode/
Cheers
Ale

 

[dirkwright]

There is a whole thread about spice models for tubes up at the top of this forum.

 

[jackinnj]

Here you are
6?52? / 6Z52P in triode mode | Bartola Valves
Cheers
Ale

I think we both ran the tube rather "hot" -- mine shows Ia of 50mA@ Va=100, Vgk=-0.5, yours 40mA -- as you suggest the values are probably scattered all over the lot.

I couldn't get a good fix on the Vgk=0.

 

[mogliaa]

Yes, the variance is high. I only found one valve out of 20 to be close to the specs. This one is the one I traced
Ale