• WARNING: Tube/Valve amplifiers use potentially LETHAL HIGH VOLTAGES.
    Building, troubleshooting and testing of these amplifiers should only be
    performed by someone who is thoroughly familiar with
    the safety precautions around high voltages.

Hammond transformer questions

Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
I've got some very basic question about Hammond transformers. Both power and output. My next project is going to be my first venture into tube power amps, so I've never worked with output transformers. Hammonds are easilly available, so 'm going to use those (1650 series). I don't get (and I'm sure it's very basic) the primary impedance rating. The 1650T states 1900 ohms C.T. Does this simply mean it's center tapped and anode to anode impedance is 1900 ohms, or does it have an impedance of 1900 ohms from the center tap to each anode connection, so 3800 ohms in total?

Same goes for hammond power transformers (e.g. 700 series). It states 750V C.T. Does that mean 750-CT-750 or 375-CT-375 (750 total).

I'm sure it's basic stuff, but very confusing for someone who's never workes with these power amp components. Thank!
 
If you have 750V with a center tap then it's just that.A 750V winding with a CT ,the CT is then at 750V/2.
The UPT is somewath more complicated.Yes 1900 ohm CT is totaly 1900 ohm but the CT is not at 2x 950 ohm.It is 2x (1900/4).
In a PP the tube "sees" 950 ohm as long as they operate in classA,the other side "helps".With larger signals,classB situation the charge dubbles (halve impedance).
The same thing on the secundairy,if you have 0,4,8,16 ohm the 4 ohm is the center,not the 8 ohm.
Mona
 
Think of it this way:

Class A SE: a handsaw
Class A P-P - two man saw (both ends pushing and pulling)
Class B P-P - two man saw, pulling alternately.
Class C RF amp - pushing a swing for part of a cycle - tuned circuit fills in the rest of the cycle.

Class D "digital" amp - sitting on a swing with a huge machine gun, popping it for and aft at various speeds to effect motion.

GoatGuy
 
Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.