diyAudio

diyAudio (http://www.diyaudio.com/forums/)
-   Tubes / Valves (http://www.diyaudio.com/forums/tubes-valves/)
-   -   Signal->crossover->3 amps->speaker (http://www.diyaudio.com/forums/tubes-valves/228909-signal-crossover-3-amps-speaker.html)

MadsKaizer 29th January 2013 10:34 AM

Signal->crossover->3 amps->speaker
 
Hey all

I have been reading some good old books on tube amplifier design and while I was reading I had a thought, turns out this is properlu called active tube crossover.

But have anyone here tried to make a active crossover, feed it to three different tube amplifiers, and not just 3 different, but 3 amps designed to work in each their range more linear, than using 3 amps for 40hz-20khz.

My thoughts are triode push pull amps, not very high power, I would build a small version of such a setup to experiment with before investing in something like 20-30W. Maybe not active crossover, but passive adjustable with a narrow range.

I welcome you to advice me on going down this road or maybe avoid it at all cost :)

BZed 29th January 2013 11:17 AM

I did something like that several years ago. 3 way active crossover 24 dB / octive. Feeding 20 to 200 hz, 2 Hafler DH200 amps in bridged mono for the woofers, Dyne Audio Polycone 10" in .707 Q enclosres. 200 to 6000hz. 2 McIntosh MC60s driving 50mm Jordan mid range modules. 6000 to ??? hz. Triode mode Dynaco ST70 driving foster ribbon tweeters.

How did it sound..... Like live music.


All times are GMT. The time now is 03:11 AM.


vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd.
Copyright 1999-2014 diyAudio


Content Relevant URLs by vBSEO 3.3.2