diyAudio

diyAudio (http://www.diyaudio.com/forums/)
-   Tubes / Valves (http://www.diyaudio.com/forums/tubes-valves/)
-   -   Looking for Neumann N149 power supply schematic (http://www.diyaudio.com/forums/tubes-valves/217970-looking-neumann-n149-power-supply-schematic.html)

impsick 15th August 2012 04:14 PM

Looking for Neumann N149 power supply schematic
 
My friend recently had a bunch of studio gear stolen, they managed to leave the M 149 mic but took the power supply. Anyone have access to the Neumann N149 power supply schematic??? Or if someone can explain what exactly pin 5 (sensor line) is? Thanks

HollowState 15th August 2012 05:08 PM

Sorry to read about this. I hate thieves the most! While I'm not familiar with this microphone, I can make an educated guess. From what I just read at Neumann the filament voltage is regulated and uses what, in power supply terms, is remote sensing. This is a feedback line that senses the filament voltage at the tube in the microphone. Doing this compensates for any voltage drop that occurs in the connecting cable, which can be quite long. It also is run constant current which provides a soft start for the tube. I read that if you contact Neumann they are usually very obliging.

grufti 16th August 2012 07:43 PM

Try the yahoo microphone forum. It has been some time since I was active there and the group may have split into subgroups, but I'm pretty sure that they will help you out.

micbuilders : micbuilders

Best of luck - I thoroughly dislike thieves - I dislike thieves who steal tools even more ... and I had quite a few microphones stolen years ago. Curse those bastards.


All times are GMT. The time now is 08:07 PM.


vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd.
Copyright 1999-2014 diyAudio


Content Relevant URLs by vBSEO 3.3.2