WARNING: Tube/Valve amplifiers use potentially LETHAL HIGH VOLTAGES.
Building, troubleshooting and testing of these amplifiers should only be
performed by someone who is thoroughly familiar with
the safety precautions around high voltages.
Probably not. What Kay says, strip 1cm of each sleeve and you will find a double wire coming out of some. Take an aspirine (Bayer works great) and hold your iron on both wires until they are tinned. Make shure there's a good solder joint between both wires.
Thanks for reply. Each black sleeves had 2 wires, I had scrapped away the insulation, tinned them, but the resistance is Mega ohm and not zero. Seems like they are not shorted together. I will try and measure them again, thanks for your help again.
