diyAudio (
-   Tubes / Valves (
-   -   new C3g/211PSE comments pls (

louischia 21st July 2011 08:18 AM

new C3g/211PSE comments pls
I have been collecting parts including PIO caps and irons for the longest time for my GM70 SET with the slightest idea about the correct way of calculating loadlines and reading curves.

Thanks to online readings and advices from some nice gentlemen from this forum, I have collected all the parts needed except the interstage.

After auditing a 211 PSE recently, I'm toying around the idea of building a SET that can take a GM70 or two 211 in PSE configuration.

I have two pieces of 2x 10-0-10V/6A. So I can connect as 10V or 20V for GM70 or 211 filaments.

The idea now will be to install 3 sockets (1 of GM70, 2 for 211) and a switch for filament changing.

So changing from a GM70 to 2x 211 will be simply changing of tubes, switching filaments, and re-biasing.

Btw, my OPTs are Tango FX-50-7S NOS.

Any comments will be deeply appreciated.

Now questions:
1 - What ratio for the interstage that will suit a GM70 or 211 PSE?
2 - Are my voltage doubler RCA83 circuit correct?
3 - Are my loadlines correct?

- Louis

louischia 21st July 2011 08:24 AM


louischia 21st July 2011 08:41 AM



louischia 21st July 2011 08:47 AM

B+ & Bias
B+ & Bias


louischia 21st July 2011 08:48 AM

And finally, the filaments

All times are GMT. The time now is 08:59 PM.

Search Engine Optimisation provided by DragonByte SEO (Pro) - vBulletin Mods & Addons Copyright © 2018 DragonByte Technologies Ltd.
Resources saved on this page: MySQL 18.75%
vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2018 DragonByte Technologies Ltd.
Copyright ©1999-2018 diyAudio