Twist-lok caps?

Mr. dB · 4th June 2011, 05:25 PM

Who's got a good selection of twist-lok electrolytics?

I'm looking to replace the 40/40/20/20 @ 350V 4-section electrolytic in my Dyna FM-3 tuner. Closest thing I've found is a 40/40/40/40 at AES, which is probably close enough, if it's not too tall for the chassis.

astouffer · 4th June 2011, 06:02 PM

Should be just fine as long as the voltage is equal to or greater than. Most electrolytics have pretty wide tolerances anyhow.

mashaffer · 4th June 2011, 08:20 PM

CE - USA 40µFx40µFx20µFx20µF / 525V

4th June 2011, 05:25 PM	#1
Mr. dB diyAudio Member Join Date: Dec 2003 Location: Arkansas	Twist-lok caps? Who's got a good selection of twist-lok electrolytics? I'm looking to replace the 40/40/20/20 @ 350V 4-section electrolytic in my Dyna FM-3 tuner. Closest thing I've found is a 40/40/40/40 at AES, which is probably close enough, if it's not too tall for the chassis.

4th June 2011, 08:20 PM	#3
mashaffer diyAudio Member Join Date: Jun 2004 Location: Indiana	CE - USA 40µFx40µFx20µFx20µF / 525V __________________ If We The People refuse to hear the truth we will be ruled by liars.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Internal wiring twist or not ?	goodspeaker	Multi-Way	6	16th November 2009 05:41 PM
Heater circuit - to twist or not to twist	Rob11966	Tubes / Valves	19	20th July 2008 02:08 AM
which wires to twist?	Matttcattt	Chip Amps	30	1st July 2003 10:16 AM
Is it ok to twist the powersupply wires around each other?	bm_mode	Solid State	10	16th October 2002 08:49 AM

New To Site?	Need Help?
Register to Participate Search Privacy Statement Contact Us	Frequently Asked Questions Did you forget your password? Mark Forums Read


	Please consider donating to help us continue to serve you. Ads on/off / Custom Title / More PMs / More album space / Advanced printing & mass image saving

4th June 2011, 06:02 PM	#2
astouffer diyAudio Member Join Date: Jun 2004 Location: Pittsburgh, crumbling wasteland	Should be just fine as long as the voltage is equal to or greater than. Most electrolytics have pretty wide tolerances anyhow.