Hello,
Check the last page of this user manual.
http://www.tubecad.com/Octal_Aikido_PCB.pdf
DT
All Just for fun!
Check the last page of this user manual.
http://www.tubecad.com/Octal_Aikido_PCB.pdf
DT
All Just for fun!
Hello,
I have 12SN7’s installed in the octal Aikido I use(B+ := 300). I assembled the PCB thinking that I may try rolling in 12SL7’s at the input position. I have 1000 ohm resistors installed at the input position and 300 ohm resistors installed at the outputs. The 12SN7’s provide adequate gain. I never rolled in the 12SN7’s. The 1000 ohm resistors remain. I have never given them a thought until you ask. The 300 ohm resistors allow a little more current to drive longer interconnects.
DT
All Just for fun!
I have 12SN7’s installed in the octal Aikido I use(B+ := 300). I assembled the PCB thinking that I may try rolling in 12SL7’s at the input position. I have 1000 ohm resistors installed at the input position and 300 ohm resistors installed at the outputs. The 12SN7’s provide adequate gain. I never rolled in the 12SN7’s. The 1000 ohm resistors remain. I have never given them a thought until you ask. The 300 ohm resistors allow a little more current to drive longer interconnects.
DT
All Just for fun!
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.