|
|||||||
| Home | Forums | Rules | Articles | Store | Gallery | Blogs | Register | Donations | FAQ | Calendar | Search | Today's Posts | Mark Forums Read | Search |
| Tubes / Valves All about our sweet vacuum tubes :) Threads about Musical Instrument Amps of all kinds should be in the Instruments & Amps forum |
| diyAudio Sponsor | ||
|
||
 |
|
|
Thread Tools | Search this Thread |
15th October 2010, 08:56 PM
|
#1 |
|
diyAudio Member
Join Date: Jun 2007
|
Tetra Phono Builders...got problems!
Just a warning to Tetra builders. I have seen two people now make the same mistake. If your pre sounds like way to much detail or sibilance it's probably because you left the optional HF shelving resistor R9 out of the PCB. If you don't use the resistor then you have to put a jumper across R9 to make the connection for the HF caps to ground. I found out after some troubleshooting.
The manual for this pre is very confusing RG |
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| FS: GlassWare Tetra phono kit | johnsonad | Swap Meet | 7 | 31st March 2011 07:33 AM |
| Tetra phono stage | Freecrowder | Tubes / Valves | 0 | 15th February 2010 06:00 PM |
| Tetra Phono Preamp as a DAC analog stage | regal | Tubes / Valves | 3 | 6th December 2009 03:41 PM |
| Calling UK builders Simple SE, Pre & Phono advice | webby | Tubes / Valves | 9 | 18th June 2009 12:55 PM |
| Bugle phono problems... | eyevancsu | Analogue Source | 12 | 24th September 2003 10:33 AM |
| New To Site? | Need Help? |
| Page generated in 0.06170 seconds (69.46% PHP - 30.54% MySQL) with 10 queries |
