Hello
Some advice to amateur needed
I got 8 6n6pi and couple of WE 2c51 tubes .
Can I use them as PP amp ,four 6n6 parallel connected per side .and 2c51 driver as in picture ???
Any better suggestion how to use single 2c51 ?? as PP
Thanks allready !!!
Papparazzi
Some advice to amateur needed
I got 8 6n6pi and couple of WE 2c51 tubes .
Can I use them as PP amp ,four 6n6 parallel connected per side .and 2c51 driver as in picture ???
An externally hosted image should be here but it was not working when we last tested it.
Any better suggestion how to use single 2c51 ?? as PP
Thanks allready !!!
Papparazzi
Here Is Circuit of Amp Maybe somebody has some comments of outputstage
What kind of voltage and Primary Impedance would be best? I suppose total Ri is quite Low
papparazzi
What kind of voltage and Primary Impedance would be best? I suppose total Ri is quite Low
An externally hosted image should be here but it was not working when we last tested it.
papparazzi
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.