diyAudio

diyAudio (http://www.diyaudio.com/forums/)
-   Tubes / Valves (http://www.diyaudio.com/forums/tubes-valves/)
-   -   Dented ASC Caps (http://www.diyaudio.com/forums/tubes-valves/149648-dented-asc-caps.html)

marcutan 26th August 2009 08:22 AM

Dented ASC Caps
 
Hi,

I brought some ASC 50uf caps and 2 of them have dents at the side (prob damaged from shipping). Is it safe to use dented oil caps? Thanks.

Cheers,
Marcus

alejo 26th August 2009 04:07 PM

Please take a photo,

Ty_Bower 26th August 2009 04:29 PM

I'd at least put a meter across it and verify the films didn't somehow get shorted against each other.

marcutan 27th August 2009 02:47 AM

They both measured around 49uf on a fluke meter. No shorts. So I guess I will go ahead and use them.

Thanks.

kavermei 29th August 2009 02:57 PM

I have some ampohm paper-in-oils that arrived dented. They work fine though!

casouza 31st August 2009 05:23 AM

There are two simple ways to measure cap leakage (lacking a capacitor tester):

Simple procedure: set your Ohmeter to its highest Meg Ohm range, connect leads to cap tabs; the cap should briefly approach zero ohms then resistance will go up as the cap charges and should read infinity when fully charged. A reading of a few Meg Ohms or anything lower means the cap is damaged.

Slightly more complicated test: connect a 1K resistor in series with the positive tab, then connect the cap to a sufficiently high DC supply, no load after or across the cap. Measure voltage across the 1 K resistor after the cap fully charges and stabilizes.
One Volt means one mA of leakage. Throw away caps that show ANY leakage, no matter how small. They mean trouble down the road.

Good luck and watch the B+, it bites!


All times are GMT. The time now is 01:06 AM.


vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd.
Copyright 1999-2014 diyAudio


Content Relevant URLs by vBSEO 3.3.2