Working on a "powerman" type build using 6021 subminature tubes. I have built a few prototypes with both a single push pull output and one with a parallel push pull setup. I can't decide one over the other so I would like to be able to "switch" the parallel 6021 in and out of the circuit.
I am thinking to keep the heaters hard-wired and the cathode and bias resistors will be a separate setup.
So that leaves 6 connections that need to be simultaneously switched off and on. That is where I am running into an issue...relays? latch circuits? 6 pole switch of some type?
Thoughts, suggestions, comments from the peanut gallery?
Thanks!
Tim
I am thinking to keep the heaters hard-wired and the cathode and bias resistors will be a separate setup.
So that leaves 6 connections that need to be simultaneously switched off and on. That is where I am running into an issue...relays? latch circuits? 6 pole switch of some type?
Thoughts, suggestions, comments from the peanut gallery?
Thanks!
Tim
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.