diyAudio

diyAudio (http://www.diyaudio.com/forums/)
-   Tubes / Valves (http://www.diyaudio.com/forums/tubes-valves/)
-   -   is there a typo in the Tubelab SE schematic? (http://www.diyaudio.com/forums/tubes-valves/142998-there-typo-tubelab-se-schematic.html)

discomonkey 26th April 2009 11:18 PM

is there a typo in the Tubelab SE schematic?
 
I'm trying to figure out the wiring of the capacitors of the Tubelab SE. The schematic has C2 connected with negative being grounded and positive carrying the current to V2/V3. The board looks like it has this reversed. The positive is grounded on the board. So is there a typo on the schematic?

TIA

rknize 27th April 2009 01:14 AM

I believe it's the schematic that's wrong. I remember noticing this too. When using 5V filaments, this cap is shorted and the four diodes act as a bridge for both the 5842s and the 300Bs. When setup for 2.5V filaments, the diodes act as full-wave rectifiers. To make up for the lower voltage going to the 5842s from the Schottky bridge, D4 and D5 act as another bridge and provide a negative DC supply to make up the difference.

Russ

isaacc7 27th April 2009 01:38 AM

I'm pretty sure George has mentioned this on his website, maybe in the construction manual...

tubelab.com 27th April 2009 02:27 AM

OOPS. I don't remember seeing this one before. The schematic is indeed wrong. The positive end of C2 should be grounded. I will fix the schematic ASAP.

discomonkey 27th April 2009 03:12 PM

Thanks! I didn't see it on the website - just thought I'd double check to make sure my understanding is correct.


All times are GMT. The time now is 08:44 PM.


vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd.
Copyright 1999-2014 diyAudio


Content Relevant URLs by vBSEO 3.3.2