diyAudio (
-   Tubes / Valves (
-   -   "Bevois Valley" in triode, what to do with the feedback? (

pwan 24th April 2009 05:14 PM

"Bevois Valley" in triode, what to do with the feedback?

If I wired "Bevois Valley" in triode (using 560 Ohm Rk), what to do with the feedback?

A. Leave the current one as is
B. Remove them out ( i.e. no negative feedback)
C Adjust the value of feedback (if then, to what value?)


EC8010 24th April 2009 05:58 PM

According to the Mullard data sheet, you get 5W out of PP triode-connected EL84. In voltage terms, that's really not much different to 10W, so why not just try the feedback as is and see whether you like it?

To remove the feedback, undo the end of the feedback resistor going to the output transformer and connect it directly to ground.

All times are GMT. The time now is 11:45 AM.

vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.
Copyright 1999-2017 diyAudio

Content Relevant URLs by vBSEO 3.3.2