diyAudio

diyAudio (http://www.diyaudio.com/forums/)
-   Tubes / Valves (http://www.diyaudio.com/forums/tubes-valves/)
-   -   bevois valley clone from eico hf-12 iron.. (http://www.diyaudio.com/forums/tubes-valves/140666-bevois-valley-clone-eico-hf-12-iron.html)

mctavish 18th March 2009 04:28 AM

bevois valley clone from eico hf-12 iron..
 
so i wire up a clone using the schematic from the mj book i recently received. i used the transformers from an eico hf-12 that was headed for its maker..

everything is great until i connect the feedback with the bypass cap. feedback with just resistance is fine. i have swapped the primary leads on the output trans. already so i know its not that.

i seem to get distortion on peaks when i have the cap across the feedback resistor. im taking feedback off the 8ohm tap which i assume is correct because the schematic in the book shows the o.t. as being 8 ohm. i believe m. j. used an old leak20 for his circuit.

they do seem like different values for feedback than ive seen in most amps, is this circuit just not suitable for this eico iron? what am i doing wrong? --lost in bevois valley

DigitalJunkie 18th March 2009 04:37 AM

The cap value is dependent on the particular output transformer used. You will probably have to tinker with the value of the cap to find what works best for that particular OPT. (A scope and sig. gen. are the usual tools used for this)


All times are GMT. The time now is 09:21 PM.


vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd.
Copyright 1999-2014 diyAudio


Content Relevant URLs by vBSEO 3.3.2