• WARNING: Tube/Valve amplifiers use potentially LETHAL HIGH VOLTAGES.
    Building, troubleshooting and testing of these amplifiers should only be
    performed by someone who is thoroughly familiar with
    the safety precautions around high voltages.

Quad II Advice

Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
Hey there.

Apparently I have to post a few times before I can send a private email message.

So here goes.

I have replaced all capacitors and resistors inside of my Quads. Tubes are Svetlana 6L6GC's, Svetlana EF 86's, and GZ32's

I just pulled these back out of storage and would like to insure that everything is correct before I decide to use them again.

I am not interested in substantial modifications, just what may be required to make them work as well as possible.

I will attempt to run a pair of Magnepan MMG's which are inefficient and have a fairly flat impedance of 4 ohms.

They may not have the grunt, but I'll give it a try anyway.

Would any of you experienced Quad II guys like to chime in with a general "check this, replace that, keep an eye out for this post?"

Could this possibly turn into a thread that will cover all bases for Quad II owners?
 
Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.