Hammond L-100 conversion - diyAudio
Go Back   Home > Forums > Amplifiers > Tubes / Valves

Tubes / Valves All about our sweet vacuum tubes :) Threads about Musical Instrument Amps of all kinds should be in the Instruments & Amps forum

Please consider donating to help us continue to serve you.

Ads on/off / Custom Title / More PMs / More album space / Advanced printing & mass image saving
Reply
 
Thread Tools Search this Thread
Old 19th February 2008, 05:16 PM   #1
diyAudio Member
 
Join Date: Dec 2007
Default Hammond L-100 conversion

I'm working on converting an old L-100 organ amp into a guitar amp,and it seems like a no-brainer. BTW here is a link to the relevant schematic [sorry I can't find a better quality scan on the inet]

http://www.urbanmusic.com/L-100scheR.jpg

One thing I like about this particular chassis is that it can be used Marshall-style chassis down, and that puts the xformer on the right, there's room for a couple of switches near it on the rear, and the signal flow goes then from left to right across the other side which would be the front. The only slight argh moment is the 5U4 projects over the front of the chassis, hence my question 3 below.

1] you'll notice the terminal marked WH: I figure this is as good a place as any to start the signal chain but am wondering if anyone sees an easy way to use the other half of the 12ax7a and bh7 for an additional gain stage? I'm not too concerned about tone control, though any ideas would be appreciated. Is there a consensus on tone control to rob that could use the ax7a? Is there a no-brainer circuit to utilize that BH7 or AX7 for additional say pre-master gain stage?

2] I initially figured to ditch at least some of the pre-circuitry so I removed the choke that feeds the B+ to the BH7 and was wondering if it would be possible/desireable to use it in place of one of the earlier PS resistors?

3] any bad ramifications if I sub a a5U4GB for the 5U4?

4] if I wanted to throw a standby in, would it go right before the very first 50uf cap? Since this is way over 300v here, can a normal 125/250v switch be used?
  Reply With Quote

Reply


Hide this!Advertise here!
Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off


Similar Threads
Thread Thread Starter Forum Replies Last Post
oiling a hammond B3 audiofan Instruments and Amps 10 9th June 2011 08:45 PM
Hammond guitar amp conversion bluestube Instruments and Amps 11 27th July 2009 01:09 AM
How hot do Hammond chokes get? bayermar Tubes / Valves 4 21st April 2008 03:06 PM
FS: Hammond Enclosures davidhs Swap Meet 2 18th April 2007 03:52 PM
FS: Old Hammond Iron pjanda1 Swap Meet 0 15th February 2006 09:02 PM


New To Site? Need Help?

All times are GMT. The time now is 03:09 PM.


vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd.
Copyright 1999-2014 diyAudio

Content Relevant URLs by vBSEO 3.3.2