• WARNING: Tube/Valve amplifiers use potentially LETHAL HIGH VOLTAGES.
    Building, troubleshooting and testing of these amplifiers should only be
    performed by someone who is thoroughly familiar with
    the safety precautions around high voltages.

knob with long end for alpha pots

Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
Jump to Latest
P

PRNDL

Member
Joined 2006
naturdoctor.com/Chapters/Amps/Ampersand.html
I'm in the process of rebuilding a very old HiFi amp into a guitar amp. The amp was completely replaced with new components, including alpha pots.

The old pots had D shafts that were a little bit longer than the new alpha pots, which means the old knobs won't fit (unless I drill them out carefully).

I'm looking for a set of knobs that have a long back end that would fit onto a new alpha pot.

Here's a photo of the amp. The pot is mounted on the amp chassis, and the shaft goes through a hole in the speaker baffle board and grill cloth.
FantonAmp.JPG


Any ideas?

Thanks!!
 
Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
Top Bottom