|
|||||||
| Home | Forums | Rules | Articles | Store | Gallery | Blogs | Register | Donations | FAQ | Calendar | Search | Today's Posts | Mark Forums Read | Search |
| Tubes / Valves All about our sweet vacuum tubes :) Threads about Musical Instrument Amps of all kinds should be in the Instruments & Amps forum |
| diyAudio Sponsor | ||
|
||
 |
|
|
Thread Tools | Search this Thread |
13th October 2007, 11:46 AM
|
#1 |
|
diyAudio Member
Join Date: Oct 2004
|
NTK " Teds tube mic"
"When you switch on the unit, the blue LED on
the power supply will not glow immediately, it will gradually glow brighter then stabilize. It is powered by the filament voltage in the NTK’s valve, which takes a few seconds to ‘warm up’, so the LED is in fact not only an on/off indicator, it also shows when the microphone is stable and ready for use. Although power is normally achieved in approximately 12 seconds, it is wise to allow a minute or two to really ensure that the NTK is ready for use." Can this stop large dc at output,when starting up? |
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| extend tube sockets, or tube "plugs"? | wicked1 | Tubes / Valves | 18 | 9th August 2010 11:17 PM |
| What makes an amplifier "bright", "warm", or "neutral"? | JohnS | Solid State | 51 | 13th December 2009 06:42 PM |
| Looking to "Borrow" an Amplitrex, 539C or other High-End Tube Tester in SE PA Area | baileyler | Swap Meet | 0 | 14th January 2009 02:07 PM |
| power supply schematic with a 6080 used as a "pass tube" | jarthel | Tubes / Valves | 1 | 27th May 2006 03:41 PM |
| Is it possible to get "tube sound" with just a tube preamp and chipamp output? | Spasticteapot | Instruments and Amps | 43 | 15th May 2006 05:28 PM |
| New To Site? | Need Help? |
| Page generated in 0.07775 seconds (68.97% PHP - 31.03% MySQL) with 10 queries |
