|Tubes / Valves All about our sweet vacuum tubes :) Threads about Musical Instrument Amps of all kinds should be in the Instruments & Amps forum|
Please consider donating to help us continue to serve you.
Ads on/off / Custom Title / More PMs / More album space / Advanced printing & mass image saving
||Thread Tools||Search this Thread|
|21st August 2007, 03:00 PM||#1|
Join Date: Feb 2007
SOHA Amp & PSU Layout, need feedback
I decided to build the SOHA headphone amplifier with the J113 CCS. The original article can be found at headwize:
I had a look at some layouts for that ampfilier, but none of them was suitable for my project (parts not available, tube upside down etc.).
Thus, I tried to make a new layout, with Alps pot on the board, short signal traces and solder points for wires at positions which are ideal for the planned case.
The original SOHA schematic from headwize, as well as my schematics (look a little bit different because of my layout program) and boards for the amp and the PSU can be found below.
I would need some help in locating errors, also feedback and criticism by experienced DIYers. In order to make it a bit easier for you, I copied the pin connections of the OP-amp, the tube and the J113s on the schematic.
Thanks a lot & best regards!
|Thread Tools||Search this Thread|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Eagle vs. Sprint-Layout for PCB design/layout||hollowman||Parts||11||12th January 2014 10:01 PM|
|WTB: LND150 Mosfet (for SOHA), shipped to UK||phresh||Swap Meet||0||11th January 2008 01:39 PM|
|Feedback on Gainclone PCB layout Wanted||maria_andersson||Chip Amps||29||29th September 2005 12:03 AM|
|'Local Feedback and Nonlinearity of Multistage Feedback Amplifiers'||mikeks||Solid State||62||20th July 2005 09:03 AM|
|New To Site?||Need Help?|