Rectifier tube change ... procedure? - Page 2 - diyAudio
Go Back   Home > Forums > Commercial Sector > Vendor Forums > Tubelab

Tubelab Discussion and support of Tubelab products, prototypes and experiments

Reply
 
Thread Tools Search this Thread
Old 23rd February 2012, 07:04 PM   #11
rknize is offline rknize  United States
diyAudio Member
 
rknize's Avatar
 
Join Date: Feb 2009
Location: Chicagoland
Send a message via AIM to rknize Send a message via Yahoo to rknize
Just to rule out the filament regulator going out of regulation, you can measure the DC voltage at C1 and C3. If your heater supply is a tad on the low side, the amount of hum could become dependent on variations in your mains voltage.
  Reply With Quote

Reply


Hide this!Advertise here!
Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off


Similar Threads
Thread Thread Starter Forum Replies Last Post
Tube change...what do you do? Skorpio Tubelab 6 2nd September 2011 07:53 AM
Which tube Rectifier is good enough for 5902 tube amp ? calico88 Tubes / Valves 14 30th July 2011 06:15 AM
converting tube rectifier to solid state rectifier. tubo Tubes / Valves 26 24th December 2009 01:12 AM
Anybody heard about Tarzian Silicon Rectifier for Tube Rectifier Replacement? zxx123 Tubes / Valves 4 21st February 2005 05:02 AM
Tube rectifier for VDIGC tube psu ebijma Chip Amps 2 11th March 2004 05:02 PM


New To Site? Need Help?

All times are GMT. The time now is 05:25 AM.


vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd.
Copyright 1999-2014 diyAudio

Content Relevant URLs by vBSEO 3.3.2