diyAudio (
-   Tubelab (
-   -   Simple SE more OPT questions/ideas (

kkcinc 14th October 2011 01:24 AM

Simple SE more OPT questions/ideas
"Cathode feedback is used in this diagram. The secondary of the OPT's are connected to ground on the PC board so a separate connection is not needed. Note the reverse connection of the output transformer secondaries. :confused:This is needed on many OPT's to get NEGATIVE feedback to the cathode of the output tube. If unsure of your particular OPT's try wiring the secondaries each way (swap the two secondary wires, leave the primary alone). Chose the connection that produces the lowest volume."

I think Gery at Transcendar is going to build me some custom 20w opt's with 40% ul tap. Question is-does anyone know if the transcendars need reverse connection of the opt's secondaries for UL. I know I can try it both ways, but it would be nice to get it right out of the gate.

All times are GMT. The time now is 03:16 AM.

vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.
Copyright 1999-2017 diyAudio

Content Relevant URLs by vBSEO 3.3.2