• These commercial threads are for private transactions. diyAudio.com provides these forums for the convenience of our members, but makes no warranty nor assumes any responsibility. We do not vet any members, use of this facility is at your own risk. Customers can post any issues in those threads as long as it is done in a civil manner. All diyAudio rules about conduct apply and will be enforced.

PE 250W Subwoofer Plate Amp

Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
I'm selling a PE 300-794 plate amp. 272 watts into 4 ohms @ .2% THD, variable phase control (0-180), variable crossover, built in high pass (125hz), speaker level and line level inputs, speaker level outputs, etc. The bass boost/rumble filter has been disabled (set to +/- 0db; flat) for use with a sealed sub. It's simple to set it however you want it and instructions abound online. The circuit board was resealed with silicon after the resisters were changed. There is also some gasket residual on the edge of the unit. It works perfectly. $75 plus shipping.

pj
 

Attachments

  • subamp1.jpg
    subamp1.jpg
    69.5 KB · Views: 157
Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.