Hypex 400watt plate amp w/ 17hz subsonic filter. For SALE!

[mp006ltk]

For sale is a plate amplifier I built using hypex parts and an eliot sound 17hz 36db/oct. subsonic fitler for use with peerless XXLS drivers or similar setups with either ported or passive design. It consists of the following:

1 UcD 400 AD module
1 ST power supply
1 AVEL 500VA Transfomer
1 Soft Start module
1 Tamper resistant aluminum momentary button
Single ended and Balanced connections
1 12" X 12" aluminum pannel
Fuse holder
IEC power connec tor
custom heat sink

optional but not installed:
eliot sound subsonic filter with wima caps and TI op amps
15V power supply - would need to be monted and wired to the pannel.

This all cost me about $500.00+

I'm asking $350.00 Firm

The pannel hasn't even been drilled yet to install in a speaker. I have decided to go with a much bigger sub then I had planned, and will be using a 4 Kw watt pro amp instead with my deqx for filtering.


Please ask for photos since it was too big to atatch. Thanks

[mp006ltk]

I need some of the parts off of this unti for an 8 ch amp. Thanks for your interest.