Anyone want a homemade heatsink? About 12 x 3 x 1" and four pounds of cast aluminum.
I can cut that backplane off, need to do that anyway...
Tim
An externally hosted image should be here but it was not working when we last tested it.
An externally hosted image should be here but it was not working when we last tested it.
An externally hosted image should be here but it was not working when we last tested it.
I can cut that backplane off, need to do that anyway...
Tim
Yep, it's all on my website under casting:
http://www.abymc.com/tmoranwms/Metal_Casting.html
The finned surface is *very* rough indeed, I'm going to try some finer sand. Those grooves are pretty tight and the coarse system sand I use isn't very good at it...
How 'bout $20 each?
Tim
http://www.abymc.com/tmoranwms/Metal_Casting.html
The finned surface is *very* rough indeed, I'm going to try some finer sand. Those grooves are pretty tight and the coarse system sand I use isn't very good at it...
How 'bout $20 each?
Tim
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.