FS/WTT: Older quality Kenwood stereo amplifier for Subwoofer Plate amp

[mtnickel]

Hi guys.

I've got a couple kenwood amps sitting around here and i'd like to trade just one for a sub plate amp that does around 275+rms into 4 ohms.

The kenwood amps are...
older KM-208, and a little newer km-992.
I'm sure whoever is trading would want the newer one.

Look at the scanned spec page on the amp for the 992.


The KM-208 looks identical with same power specs but could be slightly different. I find these amps to be much better than any reciever power i've used. I use one to power either my CSS spires or my Dennis Murphy MB27's. Never need to use all the power on the indicator (if i don't wanna blow the speakers). I also use one for my shiva 12" with just 1 channel. I'd say it does 200-250 @ 4 ohms. However, i'd like to have a plate amp to clean up my shelf of 1 unit and also have a crossover on the sub instead of stock 90hz.
If the sub was single 8 ohm's i'd probably just build an opamp and bridge the amp, but i'm not sure how stable it is into 2 ohms stereo(shiva is dual 8).

If anyones got a decent plate amp or i suppose an external amp would be fine. Just want one that can be used to it's full potential and does about 250+rms preferably with a crossover.

Thanks guys, Mark

Also, i may just sell 1 and add more money for a plate amp.

[thoyle]

Hey there,

I am new to this site and the posting process.

Do you still have the KM 992 Amp? While I do not have a plate amp to trade, I would be interested in a purchase of the unit. Are you interested?

Please advise.

Terry