Antek and ILP Toroids 22VAC and 18VAC

[udailey]

ALL SOLD

SOLD ILP 160VA 22VAC secondaries. This has a single pair of 120VAC primary wires and dual secondaries. When I held the MyRefC group buys I sold these along with the kits. These 3 toroids had damage to the plastic insulating wrapping tape that goes around the windings. They still work fine with no shorts but you might tape them up in a few places.
ILP Toroids 8usd each

SOLD Antek 4218 400VA 115VAC dual primary 18VACdual secondary toroid
The transformer was used to power my MyRefC build. Primary wires are about 3-4inches long and secondaries are 6 and 12 inches long.



You pay shipping. Think flat rate box. 10usd minimum but I have lots of other things for sale on the swap meet and you should be able to get a 10usd order together easily.

 

[Vladco]

pm send

 

[udailey]

1 sold and I found another so still 3 ILP 160VA and 1 Antek 4218 left

 

[e_fortier]

Hi,

I would be interested in the ILP 160VA but first confirm the primary voltage, 110, 120V etc.

Thanks,
Eric

 

[udailey]

Updated first post. Primaries on ILP toroids are 120VAC.
Praries on Antek are 115VAC.

 

[e_fortier]

Thanks for the info., the 22Vac ILP xtrm are slightly too low and shipping these to Canada will be more epensive than the units themself ;-)

Thanks,
Eric

 

[asuslover]

i want to know if you still have those 160va 22volts transformers.

 

[udailey]

Sure do. I'll list them as sold if they are sold.

 

[udailey]

Antek and 3 ILP sold. One ILP remains. Perfect for an inexpensive chip amp build. Or for an expensive build with a cheap transformer