• These commercial threads are for private transactions. diyAudio.com provides these forums for the convenience of our members, but makes no warranty nor assumes any responsibility. We do not vet any members, use of this facility is at your own risk. Customers can post any issues in those threads as long as it is done in a civil manner. All diyAudio rules about conduct apply and will be enforced.

Linear regulator PCB plus regulators

Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
Jump to Latest
mravlca

mravlca

Member
Joined 2009
ajst2duk said:
An externally hosted image should be here but it was not working when we last tested it.

I assumed that the middle C is mis labelled as 10uf - looks to be where something bigger would go as it sits across the output. I've chucked a 220uf - also the SMD 120ohm - would a 1/10W resistor be enough here?
Click to expand...

Yes, that middle cap should be 100uF-150uF (220uF is also good) and not 10uF as it is marked on the board.
SMD resistor can be low power here as it is only used to set voltage.

BR,
Ales
 
mravlca

mravlca

Member
Joined 2009
The boards are again available, now in two variants single and dual. There is no electrical difference between the two just physical. Basically is just two boards sticking together. The faulty marking is also corrected.

Also there is a new price for the PCB.
Single PCB 2.5€ per piece
Dual PCB 5€ per piece.

BR,
Ales
 

Attachments

  • reg_pcb.jpg
    reg_pcb.jpg
    433.8 KB · Views: 371
  • reg_pcb_one.jpg
    reg_pcb_one.jpg
    430.1 KB · Views: 371
Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
Top Bottom