I had some PCBs made for a Op Amp based multi-buffer circuit. It was designed with guitar and bass in mind, but it could be useful for other projects as well, volume pedals, piezo buffers, splitters, etc...
Here's where it started
They are nominally $5 each. More info/buy here. The project documents are mostly done, but I'll be updating them when I have time.
I'd be happy to answer any questions here or through PM.
Here's where it started
They are nominally $5 each. More info/buy here. The project documents are mostly done, but I'll be updating them when I have time.
I'd be happy to answer any questions here or through PM.
Little hiccup from Irene. Will ship new orders on Monday.
Assuming my amp doest not have a pre out, can i buffer the input for 2 output? 1 for amp and 1 to active sub
Last edited:
yes, that would be the same as the splitter application I've listed. I don't yet know if it will drive an isolation transformer.
wad do u mean by isolation transformer? also which config should i use and how many boards do i require for the above application? sorry i just started in diying audio
you want what I've described as the "splitter" in the document, http://www.coldcrafteffects.net/PCB_Store_files/Micro Buffer Build Doc.pdf
I'm working on Wiring Diagrams and fleshing out the info in the document, but I might lose power this weekend.
An isolation transformer would allow you to disconnect the grounds of the two outputs. Some applications might cause excessive hum without it, but I haven't had a chance to test whether it can drive a small 1:1 transformer yet, though I suspect it will.
I'm working on Wiring Diagrams and fleshing out the info in the document, but I might lose power this weekend.
An isolation transformer would allow you to disconnect the grounds of the two outputs. Some applications might cause excessive hum without it, but I haven't had a chance to test whether it can drive a small 1:1 transformer yet, though I suspect it will.
you want what I've described as the "splitter" in the document, http://www.coldcrafteffects.net/PCB_Store_files/Micro Buffer Build Doc.pdf
I'm working on Wiring Diagrams and fleshing out the info in the document, but I might lose power this weekend.
An isolation transformer would allow you to disconnect the grounds of the two outputs. Some applications might cause excessive hum without it, but I haven't had a chance to test whether it can drive a small 1:1 transformer yet, though I suspect it will.
alright. will wait for your updates. Will be getting from you when stock arrives.
New projects coming soon, http://coldcrafteffects.net/PCB_Store.html
Last edited:
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.