diyAudio

diyAudio (http://www.diyaudio.com/forums/)
-   Swap Meet (http://www.diyaudio.com/forums/swap-meet/)
-   -   FS: (consolidated finally) NHT A1 mono/sub amp, QSC PLX-1602 amp,Maggie MMGs,Polk sub (http://www.diyaudio.com/forums/swap-meet/184345-fs-consolidated-finally-nht-a1-mono-sub-amp-qsc-plx-1602-amp-maggie-mmgs-polk-sub.html)

taloyd 3rd March 2011 06:07 PM

FS: (consolidated finally) NHT A1 mono/sub amp, QSC PLX-1602 amp,Maggie MMGs,Polk sub
 
3 Attachment(s)
Hello,

Should of consolidated these all to begin with...

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ ~~
I have a NHT A1 monoblock (full-range, but also a great sub-amp).

Have a NHT A1 amplifier, which is usually used for subwoofers but is actually completely full-range. On those lines, the amp does NOT have a low-pass crossover, gain, or phase control, so all that must be handled by the active crossover/HT receiver/etc. up the signal chain.

The amp sounds great though, and the auto-on and balanced XLR-in are great features.

Have the original box/manual.

$150 local, $170 shipped to the west coast, $180 shipped to the east coast.

Amp is 200/300 watts RMS into 8/4 ohms.

Electronics | Mono Amplifier | High End Home Theater
http://www.onecall.com/product/NHT/A...fier/_/R-15948

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ ~~
Have a great QSC amplifier I'm selling to pay for a bigger one. Only used at home for a home stereo. In perfect condition, though I don't have the original box.

Found a great box from a previous amplifier in the closet - so can ship this out. Shipping would be $30 on west Coast and $40 towards the east. This is a GREAT amplifier for the sub/woofer section on an active 2/3/4 way.


Specifications, from this site: QSC - PLX Series Amplifiers

STEREO MODE, Both Channels Driven
8 ohms 20 Hz-20 kHz 0.03% THD: 300W
4 ohms 20 Hz-20 kHz 0.05% THD: 500W
2 ohms 1 kHz 1% THD: 800W

BRIDGE MONO MODE
16 ohms 20 Hz-20 kHz 0.1% THD: 600W
8 ohms 20 Hz-20 kHz 0.1% THD: 1100W
4 ohms 1 kHz 1% THD: 1600W
Signal to Noise (20 Hz-20 kHz): <-107 dB
Input Sensitivity @ 8 ohms: 1.2Vrms
Input Sensitivity @ 4 ohms: 1.1Vrms
Voltage Gain: 40x (32 dB)
Output Circuitry: AB
Power Requirements (1/8 Power Pink Noise @ 4 Ohm): 10A

* Exclusive PowerLight power supply for superior bass and lighter weight
* Ultra-low distortion (0.03% THD at 8 ohms) & studio-quality noise floor (-107 dB)
* LED indicators include bridge mono and parallel input modes
* Compact 2 RU, 21 lbs. and 13" deep chassis fits into any rack
* Selectable clip limiters and subsonic filters reduce distortion and protect speakers
* Variable-speed fan for low noise and solid 2 ohm performance
* Both 1/4" TRS & XLR inputs, Speakon® and shock-proof binding post outputs
* 3-year warranty plus optional 3-year extension available

Owner's manual: http://media.qscaudio.com/pdfs/plxuser.pdf
PLX series specs: http://media.qscaudio.com/pdfs/plxspec.pdf
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ ~~

Carver Pro ZR1000

One of the best amps I've ever heard (went from a pair of Monarchy SM-70 Class A monoblocks to the Carver...) I am the original owner of the Carver... have the box and manual. I had the dealer replace the fan (yes, it's unfortunately fan-cooled) with a quiet one, which is pretty inaudible from more than a few feet away.

$270 local/$300 west coast/$310 east coast

Specs are:

225 wRMS @ 8 ohms stereo
350 wRMS @ 4 ohms stereo
700 wRMS @ 8 ohms bridged mono

Has Speakon outputs, etc., selectable 40/80 Hz. high-pass filter, clip limiting, etc.

Specs (from my Dropbox):
http://dl.dropbox.com/u/1665409/CARV...000%201600.pdf

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ ~~

A used pair of Magneplanar MMGs, in great condition, though an older pair. Friend of mine recently moved into a smaller apartment and doesn't have room for them. $300 for the pair, definitely local pickup only. Used with the home theater receiver below.

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ ~~

Harmon Kardon AVR 310 receiver for sale. Really nice unit, tons of features, and a great amplifier section.

Here's the factory specs sheet:
http://www.harmankardon.com/resource...ion/AVR310.pdf

50 watts continuous, high current high bandwidth amplifier section (hi-fi watts, not Sony/Kenwood/JVC/etc. watts!)
MP3 decoding
automatic speaker calibration
Logic 7 surround processing, as well as the usual Dolby Digital, DTS, etc.
universal remote
a 2nd remote

Have original box, manual, everything!

This receiver has GREAT reviews on Audioreview.com:
Harman Kardon AVR 310 Reviews

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ ~~

Polk Audio PSW10 10" powered subwoofer for $60. Sorry, local pickup only.

taloyd 5th March 2011 08:29 PM

H/K receiver sold
 
Receiver sold!

thanks,
-Tal

taloyd 6th March 2011 07:57 PM

Polk Audio subwoofer sold
 
QSC amp, Carver amp, and Magnepan speakers still available (the Magneplanars MMG only available locally in Los Angeles, thanks).

-Tal

taloyd 14th March 2011 03:40 PM

QSC, Carver Pro, and NHT amplifier still available; receiver, subwoofer, and Magnepan MMGs all sold.

thanks,
-Tal

taloyd 15th April 2011 04:40 AM

ALL SOLD!
 
Everything sold, thanks!


All times are GMT. The time now is 07:48 AM.


vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd.
Copyright ©1999-2014 diyAudio


Content Relevant URLs by vBSEO 3.3.2