I've got 2 pairs (4 total) 0.33uF VCaps available from an old amplifier that are no longer being used. The values aren't suitable for the amplifiers I am using now so I've decided to sell them, if they were suitable I would be using them without question.
4x VCap 0.33uF 600Vdc TFTF Teflon Capacitors
Capacitance: 0.33uF +/- 5%
Voltage (DC): 600V
Dimensions (Inches): 1.27" x 2" (33mm diameter x 50mm long) (body)
The leads are original, straight and 35mm long, so nearly full length. Usage is low, I estimate around 200 - 250 hours total, so barely broken in.
The VH Audio V-Cap don't really need any introduction, arguable the best coupling cap available, etc, etc.
Retail pricing on these is around 170USD each from partsconnexion, etc. I am selling for 175AUD/pair, which is approx 160 USD or 80 USD each, so quite a big saving over than retail.
I am located in Australia but will post worldwide. Payment would be via PayPal or direct deposit for buyers in Australia. Shipping costs would be $10 (registered) within Australia, or $25 for registered airmail to worldwide.
4x VCap 0.33uF 600Vdc TFTF Teflon Capacitors
Capacitance: 0.33uF +/- 5%
Voltage (DC): 600V
Dimensions (Inches): 1.27" x 2" (33mm diameter x 50mm long) (body)
The leads are original, straight and 35mm long, so nearly full length. Usage is low, I estimate around 200 - 250 hours total, so barely broken in.
The VH Audio V-Cap don't really need any introduction, arguable the best coupling cap available, etc, etc.
Retail pricing on these is around 170USD each from partsconnexion, etc. I am selling for 175AUD/pair, which is approx 160 USD or 80 USD each, so quite a big saving over than retail.
I am located in Australia but will post worldwide. Payment would be via PayPal or direct deposit for buyers in Australia. Shipping costs would be $10 (registered) within Australia, or $25 for registered airmail to worldwide.
An externally hosted image should be here but it was not working when we last tested it.
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.