• These commercial threads are for private transactions. diyAudio.com provides these forums for the convenience of our members, but makes no warranty nor assumes any responsibility. We do not vet any members, use of this facility is at your own risk. Customers can post any issues in those threads as long as it is done in a civil manner. All diyAudio rules about conduct apply and will be enforced.

FS : Prototype PCB Specially Designed for Op-Amps

Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
Jump to Latest
xtaltech

xtaltech

Member
Joined 2004
Hi Everyone,

I have some double-side, lead free, PCBs which are specially designed for SOIC-8 single and dual Op-Amps. On the component side there are 6 locations for filter (decoupling) capacitors. On the bottom side are ground (0 volt), +ve and -ve supply rails which run across the board. Along the +ve rail there are bare points that can be jointed directly to pin 7 or 8 (for single and dual op-amp respectively).

Please note that all the holes are 0.7 to 0.75mm in diameter.

Dimensions : 2.8" x 2.4" (74mm x 61mm)
Thickness : 1.6mm
Selling for USD2.50 each

Postage for the US 48 lower states is USD2.00 for ANY number you buy.
Buyers outside USA please email for shipping quote.
I only accept PayPal.

email xtaltech@yahoo.com

An externally hosted image should be here but it was not working when we last tested it.
An externally hosted image should be here but it was not working when we last tested it.
An externally hosted image should be here but it was not working when we last tested it.
 
xtaltech

xtaltech

Member
Joined 2004
Another lot of new boards arrived yesterday. All backordered items were shipped this morning. Sorry for the short delay.

There is still enough quantity to fulfill any order.

Shipping to USA lower 48 states is USD2.00 for any number of boards you buy.

Worldwide shipping is USD3.00 for any order size.
 
Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
Top Bottom