diyAudio

diyAudio (http://www.diyaudio.com/forums/)
-   Swap Meet (http://www.diyaudio.com/forums/swap-meet/)
-   -   Pass F5 clone parts for sale (http://www.diyaudio.com/forums/swap-meet/141679-pass-f5-clone-parts-sale.html)

wirewiggler 3rd April 2009 04:28 AM

Pass F5 clone parts for sale
 
2 Attachment(s)
I decided 8 Amps is enough I donít need another (actually I am building #9 - 5 channels for the living room but that doesnít count). So I decided to sell the parts I have collected for a Pass F5 clone. I am selling at what the parts cost me $280 US, donít bothering offering me less as I would just as soon build it as take a loss. All parts are new & unused.

Included is:
2 Large heat sinks ( a bit unusual in milling on component side) Black on fin side and they look new.
Plytron 18V 300VA toroid transformer new.
Cviller power-supply board populated with 8 15000 MFD 63 V caps & 6 .47 OHM resisters.
6amp filtered power entry module w fuse holder & switch
2 10 A rectifiers
4 Manly rubber feet.
Cviller F5 boards.
Tec DIY Fairchild F5 kits ( one board components mounted to verify fit (did not mount fets).
Gold plated speaker and RCA terminals

All for $280 US + frt


Bill

trans 8th April 2009 10:55 PM

Hi Bill,

What else if needed other than enclosure? Did you have an enclosure in mind? Never built an amp so it would be a stretch for me, but this seems doable.

Thanks,

Thom

wirewiggler 9th April 2009 03:01 AM

You would have to come up with the enclosure, I would mount some 3/8 X 3/8 square aluminum bars on the heat sinks and screw plates for the front back and top and bottom to them, and of course some wire, I have been using the Teflon coated stuff Steve at Apex jr sells. I would not say this is a beginner project however as amp projects go they don't get much simpler. It is well documented and when completed it would be a keeper as the F5 is an outstanding sounding amp. I decided to make a few upgrades on my F4s and continue using them. If the metal thing is an issue I need to buy and cut some up for myself I could cut some for you but it will drive shipping up.

Bill


All times are GMT. The time now is 09:45 PM.


vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd.
Copyright ©1999-2014 diyAudio


Content Relevant URLs by vBSEO 3.3.2