I'm selling a mono block pair of professionally built, walnut tube amp chassis I purchased used from Steve Deckert of Decware for a DIY project. They are truly beautiful and I hate to get rid of them, but unfortunately my design became too physically large to fit on these chassis. They need to be re-finished with some light sanding + oil or laquer. There are no pits or dings, just the existing finish is worn and splotchy in some places. Since they are in the same condition I bought them in, and have not seen any use since I owned them, I would like to get what I purchased them for. $160USD+shipping for the pair.
Dimensions in inches:
Inside: 5.75 x 13.25 x 2
Outside: 7.25 x 14.75 x 2.75
Top plate required 14 x 6.5
Dimensions in inches:
Inside: 5.75 x 13.25 x 2
Outside: 7.25 x 14.75 x 2.75
Top plate required 14 x 6.5
An externally hosted image should be here but it was not working when we last tested it.
An externally hosted image should be here but it was not working when we last tested it.
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.