FS: Tubes and Iron

[N1ESE]

Selling the following:

Hammond 374BX Power Transformer. 375-0-375, 175 ma. Universal primary (100, 110, 120, 200, 220, 240 VAC 50/60 Hz.) and also has two filament windings (5 VCT, 3 A & 6.3 VCT, 6 A). Price: $85.00 with shipping included.

Hammond 193H Power Choke - 5H @ 200 ma. DC - Very little use, less than 24 hours total, with perfect leads. Price: $20 with shipping included.

Matched Pair of KT88EH tubes. These were purchased new from Jim McShane about 2 weeks ago and have seen less than 24 hours use in a SET configuration. Price: $45 with shipping included.

As noted above, all prices include free shipping. However, this applies to addressees in the lower-48 US states. I will ship internationally for an additional fee to cover the extra postage necessary.

Email if interested.

[N1ESE]

Power iron and choke are tentatively spoken for.

I'm lowering the price of the KT88's to $40 delivered.

[N1ESE]

Power iron and choke have been sold. Pair of KT88EH's still available.

[n_maher]

Oh no, what happened to the Simple project?!?!

[N1ESE]

Originally posted by n_maher
Oh no, what happened to the Simple project?!?!

It rocks. However, I want a headphone amp and I'm short on cash for an oral surgery I need to have done next week (no dental insurance right now). I'm going to start on a headphone amp after new years. Had I known I'd be going under the knife, I wouldn't have started on this project. Had to build it an listen though once all the parts were here.

[n_maher]

Originally posted by N1ESE


It rocks. However, I want a headphone amp and I'm short on cash for an oral surgery I need to have done next week (no dental insurance right now). I'm going to start on a headphone amp after new years. Had I known I'd be going under the knife, I wouldn't have started on this project. Had to build it an listen though once all the parts were here.

Oh crikey, you should have just asked. We could have provided you with a suitable low cost headphone amp that would have allowed you to keep the Simple! Not to completely derail your thread but since you mentioned a Millett MAX somewhere else feel free to shoot me a email about that. I was the one who spearheaded the original revised Millett low-voltage hybrid design and I'm sure I've got a boat load of parts kicking around.