WTB Heathkit power transformer

[Burnedfingers]

I need the power transformer from a Heathkit model IP2717 or IP17 power supply to replace a shorted one.

 

[jackinnj]

The original HT trannie is 175VAC for bias, 210VAC for the B+ and 600VAC center tapped for the C-.

You are probably better off looking for the Eico, Fluke or old HP supply -- the Eico 1030 is a nice lab supply for tubies.

 

[KBK]

I didn't leave the house at all today..but Jack..you gotta gotta get out more often. Way too much time in the innards of old gear.

 

[jackinnj]

I didn't leave the house at all today..but Jack..you gotta gotta get out more often. Way too much time in the innards of old gear.

I even went to the Y today, gotta keep the BP and cholesterol down.

I just happen to have a hyped-up IP-17, and I used this power supply for the MC-Tracer article.

 

[Burnedfingers]

The original HT trannie is 175VAC for bias, 210VAC for the B+ and 600VAC center tapped for the C-.

I'm showing a 175 for bias, a 210 for b+ and a 300 not center tapped for C-

This is according to the model SP-2717A regulated power supply service manual.

 

[jackinnj]

I have an IP-17 -- I modified it for microprocessor control in the MCUTracer article for AX

 

[Burnedfingers]

2717A supply