searched enough for drivers ....INDIA

[SoundsGreat]

Hey Sumit,

Thanks a lot fr the reply Bro,Ya I noticed the two diff drivers wts main diff btw the 2 N also wts the dia of the driver ?

By the way forgot only 2 ask U bout the tweeter tht U hv put in the box
Am also vry much interested in building a 2 R 3way tower with a nice sub,as U hv said tht the Amp thing is available fr diy so wts the thing N hw do I get those.


will gv U a call one of these days .

Regards,

[sumit]

hi soundgreat

The cone dia. of the mid drivers are the same just that the outer dia of the BP basket is a bit bigger.

The tweeters r Vifa XT25, that i bought from Germany for 65euros each.


The amp is a bridgeable MOSfet unit and can provide 60v p-p on a 4ohm load continuously ( with a little modification u can get 65 to 70 v p-p on 4ohms ). It has its own power supply and a optional ALC built in. Another pcb is there with other needed cks. ie. 2nd order low pass filter, link. trans., infra sub filter, buffer. Both the PCBs are available with me. For the components u can buy yourself, or i can send u whatever u can't find in your locality or if its cheaper here in Delhi.

How to buy these from me needs to be discussed separately or on the trading part of this site, so if u need any further trading q?? let take this to the trading section. For any tech q?? continue here as long as u like.....

Best Rgds

[SoundsGreat]

Hi Sumit,
I tried to mail U bt din go through,so Am writing here
Plz rply.

[BHTX]

Profile For sumit:
Last Post: 03-22-2007 10:56 PM
searched enough for drivers ....INDIA

..I doubt you'll get anything.

[palesha]

I don't think this is proper way to make drivers.
As sumeet suggested, to get proper Qts, Vas, etc. etc. u hv to buy good speaker designing software costing xxxx dollars. Then u must hv proper parts to assemble as per the design.
hope this will open eyes.
I think summet got rid of his excess parts.

[renjiish]

Man I became a big fan of you. It is undoubtedly very beautiful, and appreciates your craftsmanship.

[SoundsGreat]

Hi,

I dun Who U refer 2 in Ur post ,Bt jst wntd 2 ask U wt excatly U mean by tht ? N who U R refering 2 ?

[ashok]

SoundsGreat ,
You seem to spend all your time sending sms's. Your hands are locked on to truncated words.

It's OK to use normal text here.
Most of us generally respond favourably to normal text and haven't much time to decipher things like "...Bt jst wntd 2 ask U wt excatly U mean by tht ..." etc.

You would understand , wouldn't you ?

[mhtplsh]

Just visit this site to know about magnet(motor) assembly design software.

http://www.loudsoft.com/default.asp?site=FINEMotor.asp

U will understand more about the technology required to make good motor design.

it is not possible to just assemble & get results.
it requires expertise, experience & type of components required on ur hand.

If anybody can explain me that driver design can be done just by some calculations without any equipments & technical data of the components, I will salute him.

[SoundsGreat]

The Above qustion is for both palesha and renjiish.

Plz dun mind I ws jst curious so asked