vent-design

[keyser]

hi all!
I've been looking at the formulas for a while, but I still don't get it completely. Could anyone tell me what the effects to Fb are, when you make the port longer, increase width, or increase the number of ports.

 

[richie00boy]

Longer vent = lower Fb
Wider vent = higher Fb
More vents = wider vent = higher Fb

The wind noise is dependent on the frequency of Fb and the diameter of the vent. Lower tuning makes less noise. Wider vent makes less noise.

 

[keyser]

Thanks!

More vents = wider vent = higher Fb

Is this about the total surface area of the vent? two 10 cm^2 vents amounts to the same Fb as one 20 cm^2 vent?

 

[richie00boy]

It is about the cross-sectional surface area, but 2x 100mm vents are not the same area as 1x 200mm vent Remember area is Pi * radius^2

 

[keyser]

I wasn't talking about two 10cm diameter ports, but two 10 cm (square) ports. Guess my assumption was right then, wasn't it?

 

[Rademakers]

It was correct (maar niet helemaal ),

In practice it can be slightly different because two smaller ports have a different effect on the air in the port as one port has. That's also why rectangular ports have different effects than round ports (a round one would be, again slightly, better).

If I'm not mistaken the newer versions of WinISD (Pro) take this into account. The differences aren't huge but are there.

Mvg Johan

 

[richie00boy]

Yes, you were right keyser. Sorry.