Hi everyone,
I'm searching for informations about limiters and few good things were found, in additional I noted that the user experience is really important when setting the parameters to maximize the system efficiency and keep things protected at the same time, so I'm proposing a thread as database to collect as much as possible user's informations that could be used by everybody.
Limiter data
Enclosure type: TH, FLH, Vented, Sealed, etc (hugh influence at drivers heat transfer)
Driver Supplier: B&C, 18sound, Eminance, etc
Driver Model: XXXX
Driver Power Rate: YYYY [W] , continuous, peak, etc
RMS Limiter Applyed: Z % of Power Rate
Peak Limiter Applyed: W % of Power Rate
Notes: General comments as if the current amp is underpowered so it defines the peak limiter at your application, etc
Regards,
I'm searching for informations about limiters and few good things were found, in additional I noted that the user experience is really important when setting the parameters to maximize the system efficiency and keep things protected at the same time, so I'm proposing a thread as database to collect as much as possible user's informations that could be used by everybody.
Limiter data
Enclosure type: TH, FLH, Vented, Sealed, etc (hugh influence at drivers heat transfer)
Driver Supplier: B&C, 18sound, Eminance, etc
Driver Model: XXXX
Driver Power Rate: YYYY [W] , continuous, peak, etc
RMS Limiter Applyed: Z % of Power Rate
Peak Limiter Applyed: W % of Power Rate
Notes: General comments as if the current amp is underpowered so it defines the peak limiter at your application, etc
Regards,