diyAudio

diyAudio (http://www.diyaudio.com/forums/)
-   Subwoofers (http://www.diyaudio.com/forums/subwoofers/)
-   -   Ported Enclosures, VAS and Tuning (http://www.diyaudio.com/forums/subwoofers/229559-ported-enclosures-vas-tuning.html)

permo 7th February 2013 07:46 PM

Ported Enclosures, VAS and Tuning
 
Is there any reason why a ported enclosure should not exceed the VAS of the driver by volume? Also, is there any reason why you wouldn't want to , if possible, tune this same enclosure below the FS of the driver to extend the low end?

OscarS 7th February 2013 08:36 PM

Vas is merely a technical specification, not an enclosure requirement, even though they have the same units (volume).

Vas is used in conjunction with the other T/S parameters to form a complete picture of frequency response (predicted). Alone, the only thing this parameter tells you is only what it specifies: a volume of air having the same compliance when acted upon by a piston of the same Sd as a particular speaker---nothing more, nothing less.

One thing you could apply across the board in a very broad generalization, is that the larger the enclosure is, the lower the mechanical power handling of the speaker.

As far as tuning, depending on the other T/S parameters tuning too much below Fs could give you an excursion maximum just above Fb (the tuning frequency) that could be too high for the power requirements/input. It all depends on the final enclosure alignment and the actual speaker in question. Enclosure modeling via WinISD, Horn Response, Akabak, etc would give you actual insight into all these things without having to rely on broad generalizations.


All times are GMT. The time now is 08:31 PM.


vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd.
Copyright 1999-2014 diyAudio


Content Relevant URLs by vBSEO 3.3.2