Go Back   Home > Forums > >
Home Forums Rules Articles diyAudio Store Blogs Gallery Wiki Register Donations FAQ Calendar Search Today's Posts Mark Forums Read

DIY Servo Sub- need help with control circuit
DIY Servo Sub- need help with control circuit
Please consider donating to help us continue to serve you.

Ads on/off / Custom Title / More PMs / More album space / Advanced printing & mass image saving
Thread Tools Search this Thread
Old 28th January 2013, 11:49 AM   #1
flyingtele is offline flyingtele  New Zealand
diyAudio Member
Join Date: Jun 2009
Default DIY Servo Sub- need help with control circuit

I am designing a 15" driver with high power handling and high excursion, and would like to incorporate a servo feedback system into it.
I plan to use a second small voice coil attached to the inside of the dustcap with its own magnet assemby, doesnt need to be big as it will only be acting as a transducer to give an output waveform that represents the cones movement.
What is the best way to take this signal, to compare it against the original and make any adjustments needed to reduce distortion etc?
I thought of using opamps to split the incoming signal, feeding it to the amp and also combining it with the output from the transducer coil, phase inverting it so that the two signals largely cancel each other out, in theory leaving the distortion component of the signal, that can then be inverted and sent to the amplifier.
Is this along the right lines or am I way off? What is the best way to achieve this? Any thoughts or suggestions would be welcome. I have had a look at other threads and there is some discussion on available kits or different ways of getting the feedback signal, but I couldn't find any info of relevance to my question. All help is greatly appreciated, thanks in advance
  Reply With Quote
Old 28th January 2013, 07:57 PM   #2
Inductor is offline Inductor  Portugal
diyAudio Member
Inductor's Avatar
Join Date: Feb 2006
Location: Cascais
You can ask the administrator to move your post to the opamps section.
Not a common question here, and I'm not sure if it was already a subject.
  Reply With Quote


DIY Servo Sub- need help with control circuitHide this!Advertise here!
Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Does anybody know how to use the MCU to control the CD servo? zhangzq71 Digital Source 0 19th December 2008 03:52 AM
Please explain a servo circuit ppcblaster Chip Amps 6 18th June 2007 12:02 PM
CDM 9 and servo circuit experts? tubenut Digital Source 8 1st April 2005 12:53 AM
Sample/hold DC servo circuit IVX Tubes / Valves 7 14th March 2005 08:08 PM
CDM9 servo/control pcb.....replacing the opamp tbla Digital Source 6 30th September 2004 01:28 PM

New To Site? Need Help?

All times are GMT. The time now is 07:05 AM.

Search Engine Optimisation provided by DragonByte SEO (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.
Resources saved on this page: MySQL 15.79%
vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.
Copyright ©1999-2017 diyAudio