Small Tower Subwoofer Project

Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
Somehow this paragraph didn't make it into my past last night...

From some reading research, it seems the answer to how much is "try it and see". Most seem to pretty much fill the TL with insulation, but then "vary" it to get the right sound. The problem is there also seems to be the "speaker break-in period" problem. So getting the speaker to sound good "now", does not mean it will sound good "later".

Ideas on how to deal with this?
 
Your drawing shows more a MLTL with a very long vent, so personally would line the closed end, one side and back with 1" acoustical fiberglass insulation and damp the vent as required to quell any audible pipe harmonics, but most folks around here use polyfil, so stuffing the cab proper with around 0.3 lbs/ft^3 and add some as required in the vent tube.

Note that there was a thread not long about stuffing types IIRC, so do a 'loudspeakers' forum search to get more opinions. Seems that a shredded jeans? based product was very popular.

Well, I guess it might not be acceptable for some golden eared types that believe they can hear a slight tuning shift in the bass over time that typically occurs, but us mere mortals can't.

GM
 
Last edited:
Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.