Tapered Quarter-Wave Tube Tapered Quarter-Wave Tube

[gafhenderson]

with Tapered Quarter-Wave Tubes, can they be done with multiple drivers per enclosure/transmission line?

if so how does this change the design brief?

thanks.

[bjorno]

[QUOTE=gafhenderson;2873545]

..with Tapered Quarter-Wave Tubes, can they be done with multiple drivers per enclosure/transmission line?..

Hi, Yes

..if so how does this change the design brief?..

Brief: Not much but depends on how the drivers are mounted.

b

[gafhenderson]

[QUOTE=bjorno;2874620]

Originally Posted by gafhenderson

Hi, Yes



Brief: Not much but depends on how the drivers are mounted.

b

can you spare any time to give me some links or pointers for how to properly set up multiple drivers?

i have a single driver cabinet designed, and depending on how multiple drivers change the design parameters, i was just going to use 2 independent lines/cabinets stacked.

thanks.

[bjorno]

Hi,

You may find relevant info here:

General Speaker Related Articles


b

[gafhenderson]

is there software like winISD that models this type of enclosure easily? something i can use to see what the below looks like compared to the vented isobaric design winISD has suggested.

thanks.

mh-audio Tapered Quarter Wave Tube

using that it gave me this.

Fs - 37.4
Sd - 520
Fr - 37.4
inside width - 38.77
sa/sd - 1
se/sd - 3

Height (H) : 118.5 [cm]
Width(W) : 40 [cm]
Depth(D) : 53.9 [cm]

T1 : 13 [cm]
T2 : 26 [cm]
T3 : 91 - 98 [cm]
T4 : 93 [cm]

Dv : 12.9 [cm]
Lv : 19 [cm]
Pipearea : 130.7 [cm2]

Vb : 248.4 [liters]
F3 : 25.2 [Hz]

Linelength : 228.61 [cm]

[tb46]

Hi gafhenderson,

The entry point is probably Hornresp, and from there AkAbak. I don't know what the status of Martin King's mathcad design spreadsheets is, you may want to look for his website.

Regards,