I'm looking into making a subwoofer which will also be an end table, or something like that. I've seen a couple of designs for this, but was wondering if anyone has done this. Are there any extra issues that should be considered (aside from the fact that it'll probably be a really heavy end table!)?
I've only seen one kit:
but I believe this design could suffer from cone sag, is that right?
There have also been some references to doing this
(a couple other threads I can't seem to find right now)
Any thoughts you all have would be appreciated.
There are sub drivers that are rated for a downfiring position. I built a "table" using the Adire Tempest in a down-firing configuration and it works great.
There is a picture of my sub and towers on Adire's website. Here's the link .
It's at the bottom of the page. Sorry my website link doesn't work anymore. I added a glass top to the table where the inset is on top. No rattles unless you set a drink on it.
Re: subwoofer furniture
The problem with endtable subs is that placement can be a little bit difficult, paticularly if you like sitting on the couch.:)
You can see my endtables in this link. I just put them in the front corners of the room. And yes, they weigh more then 100lbs each.
half on topic,subwoofer furniture
|All times are GMT. The time now is 09:55 PM.|
vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2016 DragonByte Technologies Ltd.
Copyright ©1999-2016 diyAudio