Has anyone used a Lab-12 in a box which is slot loaded. Main reason is that it's easier to implement rather than use large area ducts which are required to cut down on duct air velocity at high Xmax.
I'm trying to make a cube . I have the MDF already and must cut tomorrow. The sheet is gradually warping in the heat ( it's lying outside the house )!
Currently I have an 18 inch cube reflex design .
Cheers.
I'm trying to make a cube . I have the MDF already and must cut tomorrow. The sheet is gradually warping in the heat ( it's lying outside the house )!
Currently I have an 18 inch cube reflex design .
Cheers.