|
|
|||||||
| Home | Forums | Rules | Articles | Store | Gallery | Blogs | Register | Donations | FAQ | Calendar | Search | Today's Posts | Mark Forums Read | Search |
|
Please consider donating to help us continue to serve you.
Ads on/off / Custom Title / More PMs / More album space / Advanced printing & mass image saving |
|
|
|
Thread Tools | Search this Thread |
|
|
#1 |
|
diyAudio Member
Join Date: May 2003
Location: Queensland, Australia
|
I'm thinking of building a subwoofer to go in a computer speaker setup and i'll probably be using a gainclone amp to power it, however i'm not sure on what to do for the crossover. I can't seem to find any simple/cheap active crossovers, ideally i would want to cut out the low frequencies going to the satellites but if this is too hard i will just have a lowpass setup. Also is a passive crossover really that bad for a sub, quality isn't of the upmost importance as this is only a computer system but still if there is a relatively simple way of building an active crossover then i'll try to do that.
|
|
|
|
|
#2 |
|
diyAudio Member
Join Date: May 2003
Location: South Otago
|
Check out kits, I built a Dick Smith one, seems good to me, I think Jaycar might have one also. Good luck
Max |
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
|
|
|
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| subwoofer with no crossover | MikeN | Subwoofers | 9 | 2nd December 2008 07:17 PM |
| Subwoofer crossover / subwoofer module design | derMichi | Subwoofers | 4 | 20th April 2006 10:31 AM |
| Subwoofer Crossover | Dj BASS AMP | Solid State | 7 | 30th December 2005 04:46 PM |
| My subwoofer Crossover & LT | merlinx76 | Chip Amps | 15 | 12th February 2005 08:08 PM |
| Subwoofer crossover point | BAM | Subwoofers | 1 | 21st December 2001 02:21 AM |
| New To Site? | Need Help? |
| Page generated in 0.07323 seconds (70.54% PHP - 29.46% MySQL) with 10 queries |