I'm thinking of building a subwoofer to go in a computer speaker setup and i'll probably be using a gainclone amp to power it, however i'm not sure on what to do for the crossover. I can't seem to find any simple/cheap active crossovers, ideally i would want to cut out the low frequencies going to the satellites but if this is too hard i will just have a lowpass setup. Also is a passive crossover really that bad for a sub, quality isn't of the upmost importance as this is only a computer system but still if there is a relatively simple way of building an active crossover then i'll try to do that.
Check out kits, I built a Dick Smith one, seems good to me, I think Jaycar might have one also. Good luck
|All times are GMT. The time now is 10:43 AM.|
vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.
Copyright ©1999-2017 diyAudio