Well,
In that case, and if you want a summing signal, just add 3 resistors and other amplifier.
at least 100k in each output of the main amplifier, join this 2 with another of 22k and then to ground.
you get the summing signal between the 2 extremes of the 22k resistor.
now, with this, you'll put into the subwoofer all the audio bandwidth. this signal is applyed to a third amplifier and...
some sound will get out of the sub.
more simple tan this, is impossible...
You can also put in parallel with the 22k resistor a 470nF cap to make a low pass filter.
I'd like to make a remark here:
This is the worst way to do this, but I'm answering to your question.
Another way is to buy a dual coil subwoofer and make a good low pass filter.
Pedro Martins
In that case, and if you want a summing signal, just add 3 resistors and other amplifier.
at least 100k in each output of the main amplifier, join this 2 with another of 22k and then to ground.
you get the summing signal between the 2 extremes of the 22k resistor.
now, with this, you'll put into the subwoofer all the audio bandwidth. this signal is applyed to a third amplifier and...
some sound will get out of the sub.
more simple tan this, is impossible...
You can also put in parallel with the 22k resistor a 470nF cap to make a low pass filter.
I'd like to make a remark here:
This is the worst way to do this, but I'm answering to your question.
Another way is to buy a dual coil subwoofer and make a good low pass filter.
Pedro Martins
audioPT said:Well,
In that case, and if you want a summing signal, just add 3 resistors and other amplifier.
at least 100k in each output of the main amplifier, join this 2 with another of 22k and then to ground.
you get the summing signal between the 2 extremes of the 22k resistor.
now, with this, you'll put into the subwoofer all the audio bandwidth. this signal is applyed to a third amplifier and...
some sound will get out of the sub.
more simple tan this, is impossible...
You can also put in parallel with the 22k resistor a 470nF cap to make a low pass filter.
I'd like to make a remark here:
This is the worst way to do this, but I'm answering to your question.
Another way is to buy a dual coil subwoofer and make a good low pass filter.
Pedro Martins
like this?
Attachments
just made this ...
built this about 2 days ago and works perfectly. -3db is 70hz for subwoofer bass. i used 741s just as testing but better op amps should be chosen. the 3.9ohm load represents the speaker.
-chris
built this about 2 days ago and works perfectly. -3db is 70hz for subwoofer bass. i used 741s just as testing but better op amps should be chosen. the 3.9ohm load represents the speaker.
An externally hosted image should be here but it was not working when we last tested it.
-chris
audioPT said:Hi Matttcattt
Just do like yhis:
(Beware that this isn't the best way)
To get better results, go active!
Pedro Martins
is the 1uf capacitor the low pass filter or do i add a 470nf as well? or do i use a 470nf one instead of the 1uf?
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- Loudspeakers
- Subwoofers
- Simple subwoofer cross-over