DIY sub with sumo A II

[Sponkii]

hey.

I have a single channel from a SUMO andromedea II

that i have the intention to drive a sub woofer.

does anyone have some good input to design and use of speaker.

my intention is to use it as a "party" woofer..

 

[aznboi3644]

Buy this
http://www.parts-express.com/pe/showdetl.cfm?Partnumber=294-690&FTR=&CFID=6428667&CFTOKEN=37640150

and a build a big enclosure for it...it should be a good "party sub"

 

[Sponkii]

speaker...

Okay that is a party woofer.. but it is WAY over my budget..

the power handling of the andromedea is around 200watt at 8ohm

 

[Sponkii]

??

could this be a possibility ?...

http://www.discoworld.dk/shop/product_info.php?cPath=302_304&products_id=6549

 

[Sponkii]

speaker

i thought about this unit.

http://www.discoworld.dk/shop/product_info.php?cPath=302_304_606&products_id=18991

here is plot

http://img514.imageshack.us/img514/9704/plot.png

im going to make it vented, but what is best one "big" vent or two smaller?

http://img504.imageshack.us/img504/6531/box.png

 

[Sponkii]

??

Is all hope lost ?

 

[bjorno]

..my intention is to use it as a "party" woofer..

For 'Party' use I vote for using a 50 L closed box.

b

1(1)

 

[Sponkii]

cabinet

Sorry...

i have already made the cabinet (or it is on the way)

went for a ventet system as i intend to use as a sub for home use as well, and i want low fs, cabi is around 90L..

 

[Sponkii]

pic

Nothing holding it together just placed together

An externally hosted image should be here but it was not working when we last tested it.

Here is the side mounted, and rear cover is being cut.

An externally hosted image should be here but it was not working when we last tested it.

most of back panel made, still not mounted.

An externally hosted image should be here but it was not working when we last tested it.

The inside:

An externally hosted image should be here but it was not working when we last tested it.

Here is it with the front.. it is not mounted yet

An externally hosted image should be here but it was not working when we last tested it.

 

[Sponkii]

progress

Everything is moving along ..

putting in trafo

An externally hosted image should be here but it was not working when we last tested it.

Switch

An externally hosted image should be here but it was not working when we last tested it.

inside with trafo mounted (standing on the side), and last hole for fuse holders is drilled..

An externally hosted image should be here but it was not working when we last tested it.